Steelwork · Exam learning

2014–2019 · Reference answers

2016-05-11 PTE — all answers

Older-paper reference: study the 2022–2024 priority route first. This page links every printed subquestion, with full original diagrams beside the calculations.

Original source: 15IIENGTY045.pdf · physical page 1

2016-05-11 · PTE. 17 inventoried subquestions, 130 marks offered. The supplied format is two hours: Section A 40 compulsory marks plus any two of three 30-mark Section B questions. Independent teaching solutions; no official answers or marking scheme supplied.

Introduction / short theory

Question / source pageMarksAnswer / status
AQ1-b · p.24Short theory: second-order
Solved and checked

Connections

Question / source pageMarksAnswer / status
BQ2-a-i · p.33Bolt shear
Solved and checked
BQ2-a-ii · p.33Bolt bearing
Solved and checked
BQ2-a-iii · p.35Plate bearing
Solved and checked
BQ2-a-iv · p.33Main plate tension
Solved and checked
BQ2-a-v · p.33Cover plate tension
Solved and checked
BQ2-a-vi · p.31Failure mode
Solved and checked
BQ2-b · p.412UB bracket welds
Conditional answer · final source check incomplete

Beams and floors

Question / source pageMarksAnswer / status
AQ1-a-i · p.24Load intensity
Solved and checked
AQ1-a-ii · p.28Beam actions
Conditional answer · final source check incomplete
AQ1-a-iii · p.24Section classes
Solved and checked
AQ1-a-iv · p.210B1 checks
Conditional answer · final source check incomplete
AQ1-a-v · p.210B2 checks
Conditional answer · final source check incomplete
BQ4-a · p.52Support reactions
Solved and checked
BQ4-b · p.514LTB: restraint positions 0, 6 m
Conditional answer · final source check incomplete
BQ4-c · p.514LTB: restraint positions 0, 3, 6 m
Conditional answer · final source check incomplete

Columns

Question / source pageMarksAnswer / status
BQ3 · p.430Biaxial column checks
Conditional answer · final source check incomplete

Use this paper as reference practice

Attempt one complete question with answers closed. Compare the first wrong decision, not only the final number. After correction, change one load, span or restraint and repeat the corresponding self-check. Prioritise recurring recent families; an older-only sketch is optional unless your lecturer includes it.